TMR Calibration

Calibration Website:

https://dualshock-tools.github.io/

Step-by-Step Calibration Instructions:

Step 1: Access the Calibration Tool

1. Open your preferred web browser on your PC or Laptop.
2. Navigate to the calibration tool website: https://dualshock-tools.github.io/
3. The tool will guide you through the re-centering process of the analog sticks. It consists of four steps where you will be asked to move both sticks in various directions and release them.

Important: Once the calibration process starts, it cannot be canceled!

Step 2: Connect and Select Your Controller

1. Plug your controller into your PC/Laptop using the USB cable.
2. On the website, press ‘Connect’.

Step 3: Start Calibration

1. Click on ‘Calibrate Stick Center’.
2. The stick will calibrate automatically.

Step 4: Calibrate stick range

1. Enter the Calibrate Stick Range section.
2. Rotate the sticks slowly at least 2 times in one direction and 2 times in the other direction to cover the whole range.
3. Press Done

(If, after this step, the analogues are in the correct positions, click save the changes permanently to complete the process)

Step 5: Additional step if the above did not help

1. Press Finetune stick calibration
2. Move the stick to select it for tuning, then without touching the stick use the D-pad buttons to adjust the center point. Flick it and adjust it again if it is off center or flickers..
3. Press the D-pad or face buttons in the direction you want the stick position to move.
4. Press ‘Done’ when the process is finished.

Step 6: Press ‘Save changes permanently’ to complete the recentering and recalibration process.

Your controller is now calibrated and ready to use. Enjoy enhanced accuracy and precision while gaming!